*Exclusive* 3pc Vortex Spiral Bit Set
Check out our new exclusive 3pc Vortex Spiral Bit Set, #314. You will not find this set anywhere else! This 3pc set includes the top selling, most requested 1/4 shank, spiral upcut, downcut and compression router bits that Vortex makes. Save an additional 10% when you purchase the Vortex 314 versus each router bit individually.
Set Includes the Following:
1230- 1/4″ Cutting Diameter, Cutting Edge Length 7/8″, Shank Diameter 1/4″, Overall Length 2-1/2″
1330-1/4″ Cutting Diameter, Cutting Edge Length 7/8″, Shank Diameter 1/4″, Overall Length 2-1/2″
3112- 1/4″ Cutting Diameter, Cutting Edge Length 7/8″, Shank Diameter 1/4″, Overall Length 3″
Router Bit Information
Vortex 1230 upcut spiral bit will provide a smooth bottom finish, while augering the chips upward. Due to the upcut design and the included angle of the cutting edge, these tools are razor sharp!
Vortex 1330 downcut spiral bit will produce a clean top edge cut of dado type, groove type, or a simple thru-cut. Down-shear bits direct chip flow downward and help hold the part onto the table or pods.
Vortex 3112 compression spiral bit is designed for mortise cuts or cutting 5/8 or thinner material. The 1/4 upcut prevents chipping & fuzzing on top & bottom of the material being cut. Mortise Cuts are grooves cut in the material usually at a depth equal to or slightly less than the diameter of the tool.
*These two flute finishing tools are used when a smooth edge cut is required and is a popular tool design for most routing applications. The helical cutting edge reduces material contact while in the cut. This is why spiral tool designs cut faster, quieter, and cleaner than straight edge tools.
Leave a Reply
